Port 3620Epson Projector Control

Control traffic for Epson projectors using TCP or UDP port 3620.

inIoT
transport
tcp · udp

2 transports registered

in transit
cleartext

payload readable on path

assignment
official

registered with iana

risk
6/10

risk

lookups
0

rank 993 of 4,349 · top 23%

also known as ep-pcp, Epson Projector Control Port

Technical Details

what runs on :3620

Epson projector implementations commonly use TCP port 3620 for the ESC/VP-style network control protocol, carrying short, text-oriented command and status exchanges after a connection is established. Commands can control functions such as power, source selection, and configuration, while queries return projector state; exact commands and framing vary by model and firmware. The registration covers both TCP and UDP, although TCP is the usual observed control transport. This service is distinct from PJLink, which commonly uses TCP port 4352.

Security Information

exposure of :3620

risk score

6/ 10risk

treat as sensitive. widely scanned and regularly exploited when reachable — restrict it to known sources.

iot averages 3.4 across 149 ports — this one sits 2.6 above.

in transit

cleartext

credentials and payloads are readable by anyone on path

assignment

official

registered with iana for this service — scanners fingerprint it by number

reachable over

tcp · udp

udp is connectionless — source addresses are trivially spoofed and it is a reflection favourite

security overview

Traffic is generally unencrypted, and projector-control deployments may provide little or no authentication at the protocol layer. An exposed service can therefore allow remote power or input changes and disclose device status; it should normally be restricted to the AV management network or protected with firewall rules and, where supported, projector access controls.

Related Ports

all 149 in iot →

the 8 most looked-up other ports in iot — 149 ports carry that label.

risk mix of the 8 listed

  • caution100%

1 of 8 encrypted